SANRAD I3.1.1205 - Manual (Page 188)

10-2 SANRAD V-Switch CLI User Manual
General Configuration Parameters
This command is
available only after
the V-Switch is
initialized with the init
command.
After the initial V-Switch configuration, you may want to change one or
more of the V-Switch parameters. For example: You may need to change
the system clock to adjust to Daylight Savings Time. You can also use this
command to add contact information of whom to contact in the event of
technical difficulties.
device set
You can define or change thirteen parameters using this command:
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
If you are working in
a V-Switch cluster,
the changes must be
configured in both V-
Switches.
-n NAME USER - ASSIGNED
NAME FOR THE V-
S WITCH
OPTIONAL VSwitch1
-ip MANAGEMENT IP
ADDRESS
IP ADDRESS OF THE
MANAGEMENT PORT
OPTIONAL 212.199.43.47
-im MANAGEMENT IP
MASK
IP M ASK FOR THE
MANAGEMENT PORT
OPTIONAL
DEFAULT :
255.255.255.0
-p UDP PORT PORT THROUGH
WHICH ALL
UDP
COMMUNICATIONS
WILL FLOW
–
NAMELY FOR SNMP
OPTIONAL
DEFAULT : 161
-if INTERFACE ALIAS ALIAS OF PORT FOR
MANAGING
V-
S WITCH
OPTIONAL
DEFAULT : MGMT
( ETH 1 OR
MGMT )
-d DATE LOCAL DATE OPTIONAL 21/07/2002
-t TIME LOCAL TIME OPTIONAL 13:30
-c CONTACT CONTACT PERSON
IN THE EVENT OF A
SYSTEM
MALFUNCTION OPTIONAL AnnaLevin
-loc LOCATION LOCATION OF THE
CONTACT PERSON OPTIONAL ext4838