SANRAD I3.1.1205 - Manual (Page 189)

Chapter 10: Routine V-Switch Maintenance 10-3
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
-rld REPORT LUN
DISCOVERY
MODE FOR
DISCOVERING
DEVICE
LUN S
OPTIONAL
YES OR NO
DEFAULT : YES
no
-telnet TELNET PORT PORT FOR V-
S WITCH
COMMUNICATIONS
OPTIONAL
DEFAULT : 23
1597
-rcom READ
COMMUNITY COMMUNITY TO
GET INFORMATION OPTIONAL
DEFAULT :
PUBLIC
-wcom WRITE
COMMUNITY COMMUNITY TO SET
INFORMATION OPTIONAL
DEFAULT :
PRIVATE
Example:
The V-Switch is named V-Switch 1 at 13:30 in the afternoon on 21 March 2002.
Its management port, eth1, has the IP address 212.199.43.46. Anna Levin, at
phone extension 4838 is the contact person in the event of technical difficulties.
device set –n VSwitch1 –ip 212.199.43.46 –d 21/04/2004 –t
13:30 –c AnnaLevin. –loc ext4838 –if eth1
Telnet Port
If you are working in
a V-Switch cluster,
the interface alias
must be changed on
both V-Switches.
If your Telnet communications connection to the V-Switch traverses a
firewall, the standard Telnet communications port 23 may be blocked by
the firewall as a security measure. To enable Telnet communications to
the V-Switch, you can designate an alternate port using the CLI command
device set -telnet
. This port can be opened in the firewall for
dedicated Telnet-V-Switch communications.
device set -telnet
Example:
The port 1597 is programmed as the Telnet communications port.
device set -telnet 1597