SANRAD I3.1.1205 - Manual (Page 75)

Chapter 4: V-Switch Configuration 4-23
iscsi discovery rportal remove
This command removes an iSCSI remote portal.
iscsi discovery rportal remove
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
-ip IP ADDRESS IP ADDRESS OF
NETWORK PORT
MANDATORY 212.199.43.70
-port TCP PORT TCP PORT FOR
I SCSI
COMMUNICATION
OPTIONAL
DEFAULT :
3260
5003
Configuring IP Routing
To enable communications between the V-Switch and IP networks located
outside the V-Switch LAN, you must configure IP routing paths for each
external network port. The IP route begins with a specified network port on the
V-Switch and ends at the external network IP address. Just as each IP address
is unique, each IP routing path is unique. There can be only one IP route to a
given external network IP address per V-Switch.
In Figure 4-6, you have two V-Switches connected to three different LANs (A,
B, C). In turn, each LAN is connected to at least one external network (D, E, F).
On V-Switch 1, network ports Eth1 and Eth2 can both access Network D:
P ORT LAN R OUTER L EG
E TH 1 A 20.20.10.20
You can configure
only one IP route to a
given external
network on your V-
Switch.
E TH 2 B 30.30.20.20
Only one of these paths can be configured for V-Switch 1.