SANRAD I3.1.1205 - Manual (Page 281)

Chapter 11: Command Line Interface 11-67
lu remove
This command removes the LU from its target. The LU must be inactive
before being removed. This command is the opposite of volume
expose
.
lu remove
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
-ta TARGET ALIAS ALIAS OF TARGET
TO REMOVE
LU
FROM
MANDATORY Pilote
-lun LOGICAL UNIT
NUMBER LU TO REMOVE
FROM THE TARGET
MANDATORY 0
lu statistics show
This command shows all statistics for configured LUNs on the V-Switch.
lu statistics show
Table 11-48: LU Statistics
LUN Target Commands Read
(MB) Written
(MB) In
Resets OutTast
SetFull
Status
0 t1 25 2500 3000 2 1
1 t2 30 3500 2500 1 2
Monitoring and Statistics
These commands enable you to view V-Switch health monitoring and
performance statistics.
C OMMAND C OMMAND
SYSTEM HARDWARE SHOW INTERFACE STATISTICS SHOW
INTERFACE STATISTICS DETAILS IP STATISTICS IP SHOW
IP STATISTICS ICMP SHOW TCP CONNECTION SHOW
TCP STATISTICS SHOW UDP LISTENERS SHOW
UDP STATISTICS SHOW