SANRAD I3.1.1205 - Manual (Page 314)

A-14 SANRAD V-Switch User Manual
Next, attach the new JBOD to the V-Switch and configure the storage port
communications as needed.
Use the CLI command
storage show
to view the attached storage. The
legacy JBOD disks are Stor_1 through Stor_4. The new JBOD disks are
Stor_5 through Stor_8.
Table A-7: Legacy + New JBOD Disks
Alias Entity Name LUN Oper. Status Subdisk
Stor_1 200507606058c90 0 Enabled entire
Stor_2 2000002037f88fb8 0 Enabled entire
Stor_3 2000002037c32b1f 0 Enabled entire
Stor_4 2000002037c32450 0 Enabled entire
Stor_5 500708206059f880 0 Enabled entire
Stor_6 500003504206a683 0 Enabled entire
Stor_7 500065470490f321 0 Enabled entire
Stor_8 500000024364h764 0 Enabled entire
STEP 2. CREATE SIMPLE VOLUMES
Use the CLI command
volume create simple
to create a simple
volume from each disk.
Use one standard for naming the legacy JBOD simple volumes and another
for naming the new JBOD simple volumes. This will provide a visual cue
when it is time to designate the source volume to replicate from.
volume create simple –vol OS1 –d Stor_1
volume create simple –vol OS2 –d Stor_2
. . .
volume create simple –vol NS3 –d Stor_7
volume create simple –vol NS4 –d Stor_8