beautypg.com

2 host mac power management, Host mac power management, Datasheet – SMSC LAN9311i User Manual

Page 48

background image

Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface

Datasheet

Revision 1.4 (08-19-08)

48

SMSC LAN9311/LAN9311i

DATASHEET

The Port 1 & 2 PHY energy-detect events are capable of asserting the PME output by additionally
setting the PME_EN and ED_EN2 (Port 2 PHY) or ED_EN1 (Port 1 PHY) bits of the

Power

Management Control Register (PMT_CTRL)

.

4.3.2

Host MAC Power Management

The Host MAC provides wake-up frame and magic packet detection modes. When enabled in the

Host

MAC Wake-up Control and Status Register (HMAC_WUCSR)

(via the WUEN bit for wake-up frames,

and the MPEN bit for magic packets), detection of wake-up frames or magic packets causes the WUFR
and MPR bits of the HMAC_WUCSR register to set, respectively. If either of the WUFR and MPR bits
are set, the WOL_STS bit of the

Power Management Control Register (PMT_CTRL)

will be set. These

events can enable PME output assertion by additionally setting the PME_EN bit of the

Power

Management Control Register (PMT_CTRL)

.

The IRQ interrupt output can be triggered by a wake-up frame or magic packet as described in

Section

5.2.6, "Power Management Interrupts," on page 53

.

Refer to

Section 9.5, "Wake-up Frame Detection," on page 117

and

Section 9.5.1, "Magic Packet

Detection," on page 119

for additional details on these features.

This manual is related to the following products: