2 reset and configuration strap timing, Figure 15.2 nrst reset pin timing, Table 15.6 nrst reset pin timing values – SMSC LAN9311i User Manual
Page 446: Section 15.5.2, "reset and, Section, D in, Config
Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface
Datasheet
Revision 1.4 (08-19-08)
446
SMSC LAN9311/LAN9311i
DATASHEET
15.5.2
Reset and Configuration Strap Timing
This diagram illustrates the nRST pin timing requirements and its relation to the configuration strap
pins and output drive. Assertion of nRST is not a requirement. However, if used, it must be asserted
for the minimum period specified. Please refer to
Section 4.2, "Resets," on page 36
for additional
information.
Note:
Device configuration straps are latched as a result of nRST assertion. Refer to
"Configuration Straps," on page 40
for details.
Figure 15.2 nRST Reset Pin Timing
Table 15.6 nRST Reset Pin Timing Values
SYMBOL
DESCRIPTION
MIN
TYP
MAX
UNITS
t
rstia
nRST input assertion time
200
μS
t
css
Configuration strap pins setup to nRST deassertion
200
nS
t
csh
Configuration strap pins hold after nRST deassertion
10
nS
t
odad
Output drive after deassertion
30
nS
t
css
nRST
Configuration
Strap Pins
t
rstia
t
csh
Output Drive
t
odad