Fortinet FortiGate-800 - Manual (Page 43)

NAT/Route mode installation Using the setup wizard
FortiGate-800 Installation and Configuration Guide
43
DMZ and user-defined interfaces
Use Table 12 to record the IP addresses and netmasks of the FortiGate DMZ and
user-defined interfaces if you are configuring them during installation. The HA
interface is configured during HA installation.
.
Using the setup wizard
From the web-based manager, you can use the setup wizard to do the initial
configuration of the FortiGate unit. For information about connecting to the web-based
manager, see
“Connecting to the web-based manager” on page 28 .
Starting the setup wizard
1 In the web-based manager, select Easy Setup Wizard (the middle button in the upper-
right corner of the web-based manager).
2 Select the Next button to step through the wizard pages.
3 Use the information that you gathered in Table 10 on page 42 to fill in the wizard fields.
You can also use the information in Table 11 on page 42 .
4 Confirm the configuration settings, and then select Finish and Close.
Reconnecting to the web-based manager
If you changed the IP address of the internal interface while you were using the setup
wizard, you must reconnect to the web-based manager using a new IP address.
Browse to https:// followed by the new IP address of the internal interface. Otherwise,
you can reconnect to the web-based manager by browsing to https://192.168.1.99.
You are now finished the initial configuration of your FortiGate unit, and can proceed
to
“Completing the configuration” on page 49 .
Table 12: DMZ and user-defined interfaces (Optional)
DMZ IP: _____._____._____._____ Netmask: _____._____._____._____
1 IP: _____._____._____._____ Netmask: _____._____._____._____
2 IP: _____._____._____._____ Netmask: _____._____._____._____
3 IP: _____._____._____._____ Netmask: _____._____._____._____
4 IP: _____._____._____._____ Netmask: _____._____._____._____
Note: If you use the setup wizard to configure internal server settings, the FortiGate unit adds
port forwarding virtual IPs and firewall policies for each server. For example, for each server
located on the Internal network the FortiGate unit adds an External->Internal firewall policy.