Viewing the interface list, Changing the administrative status of an interface, Adding an interface to a zone – Fortinet FortiGate-800 User Manual
Page 139
Network configuration
Configuring interfaces
FortiGate-800 Installation and Configuration Guide
139
Viewing the interface list
To view the interface list
1
Go to System > Network > Interface.
The interface list is displayed. The interface list shows the following status information
for all the FortiGate interfaces and VLAN subinterfaces:
• The name of the interface
• The IP address of the interface
• The netmask of the interface
• The zone that the interface has been added to
• The administrative access configuration for the interface
See
“Controlling administrative access to an interface” on page 143
for information
about administrative access options.
• The administrative status for the interface
If the administrative status is a green arrow, the interface is up and can accept
network traffic. If the administrative status is a red arrow, the interface is
administratively down and cannot accept traffic. To change the administrative
status, see
“Changing the administrative status of an interface” on page 139
Changing the administrative status of an interface
You can use the following procedures to start an interface that is administratively
down and stop and interface that is administratively up.
To start up an interface that is administratively down
1
Go to System > Network > Interface.
The interface list is displayed.
2
Select Bring Up for the interface that you want to start.
To stop an interface that is administratively up
1
From the FortiGate CLI, enter the command:
set system interface
You can only stop an interface that is administratively up from the FortiGate command
line interface (CLI).
Adding an interface to a zone
If you have added zones to the FortiGate unit, you can use the following procedure to
add an interface or VLAN subinterface to a zone.
You must delete any firewall addresses added to an interface or VLAN subinterface
before adding the interface or VLAN subinterface to a zone. For information about
deleting addresses, see
“Deleting addresses” on page 199
When you add an interface or VLAN subinterface to a zone, you cannot add firewall
addresses to the interface or VLAN subinterface and the interface or VLAN
subinterface does not appear on the policy grid.