Vlans in nat/route mode, Rules for vlan ids, Rules for vlan ip addresses – Fortinet FortiGate-800 User Manual
Page 146: Rules for vlan ids rules for vlan ip addresses
146
Fortinet Inc.
VLANs in NAT/Route mode
Network configuration
In a typical VLAN configuration, 802.1Q-compliant VLAN layer-2 switches or layer-3
routers or firewalls add VLAN tags to packets. Packets passing between devices in
the same VLAN can be handled by layer 2 switches. Packets passing between
devices in different VLANs must be handled by a layer 3 device such as router,
firewall, or layer 3 switch.
Operating in NAT/Route mode, the FortiGate unit functions as a layer 3 device to
control the flow of packets between VLANs. See
for more information.
Operating in Transparent mode, the FortiGate unit functions as a layer 2 device to
control the flow of packets between segments in the same VLAN. See
domains in Transparent mode” on page 147
VLANs in NAT/Route mode
In NAT/Route mode, FortiGate units support VLANs for constructing VLAN trunks
between an IEEE 802.1Q-compliant switch (or router) and the FortiGate unit. Normally
the FortiGate unit internal interface connects to a VLAN trunk on an internal switch,
and the external interface connects to an upstream Internet router untagged. The
FortiGate unit can then apply different policies for traffic on each VLAN that connects
to the internal interface.
In this configuration, you add VLAN subinterfaces to the FortiGate internal interface
that have VLAN IDs that match the VLAN IDs of packets in the VLAN trunk. The
FortiGate unit directs packets with VLAN IDs, to subinterfaces with matching VLAN
IDs.
You can also define VLAN subinterfaces on all FortiGate interfaces. The FortiGate unit
can add VLAN tags to packets leaving a VLAN subinterface or remove VLAN tags
from incoming packets and add different VLAN tags to outgoing packets.
Rules for VLAN IDs
Two VLAN subinterfaces added to the same physical interface cannot have the same
VLAN ID. However, you can add two or more VLAN subinterfaces with the same
VLAN IDs to different physical interfaces. There is no internal connection or link
between two VLAN subinterfaces with same VLAN ID. Their relationship is the same
as the relationship between any two FortiGate network interfaces.
Rules for VLAN IP addresses
IP addresses of all FortiGate interfaces cannot overlap. That is, the IP addresses of all
interfaces must be on different subnets. This rule applies to both physical interfaces
and to VLAN subinterfaces.
Note: You can enter the CLI command set system ip-overlap enable to allow IP
address overlap. If you enter this command, multiple VLAN interfaces can have an IP address
that is part of a subnet used by another interface. This command is recommended for advanced
users only.