Fortinet FortiGate 50A User Manual
Installation and configuration guide, Fortigate 50a
Table of contents
Document Outline
- Table of Contents
- Introduction
- Getting started
- NAT/Route mode installation
- Transparent mode installation
- Preparing to configure Transparent mode
- Using the setup wizard
- Using the command line interface
- Connecting the FortiGate unit to your networks
- Completing the configuration
- Transparent mode configuration examples
- System status
- Changing the FortiGate host name
- Changing the FortiGate firmware
- Manual virus definition updates
- Manual attack definition updates
- Displaying the FortiGate serial number
- Displaying the FortiGate up time
- Backing up system settings
- Restoring system settings
- Restoring system settings to factory defaults
- Changing to Transparent mode
- Changing to NAT/Route mode
- Restarting the FortiGate unit
- Shutting down the FortiGate unit
- System status
- Session list
- Virus and attack definitions updates and registration
- Updating antivirus and attack definitions
- Scheduling updates
- Enabling push updates
- Registering FortiGate units
- Updating registration information
- Recovering a lost Fortinet support password
- Viewing the list of registered FortiGate units
- Registering a new FortiGate unit
- Adding or changing a FortiCare Support Contract number
- Changing your Fortinet support password
- Changing your contact information or security question
- Downloading virus and attack definitions updates
- Registering a FortiGate unit after an RMA
- Network configuration
- Configuring interfaces
- Viewing the interface list
- Changing the administrative status of an interface
- Configuring an interface with a manual IP address
- Configuring an interface for DHCP
- Configuring an interface for PPPoE
- Adding a secondary IP address to an interface
- Adding a ping server to an interface
- Controlling administrative access to an interface
- Changing the MTU size to improve network performance
- Configuring traffic logging for connections to an interface
- Configuring the management interface in Transparent mode
- Adding DNS server IP addresses
- Configuring routing
- Configuring DHCP services
- Configuring the modem interface
- Configuring interfaces
- RIP configuration
- System configuration
- Firewall configuration
- Users and authentication
- IPSec VPN
- PPTP and L2TP VPN
- Network Intrusion Detection System (NIDS)
- Antivirus protection
- Web filtering
- Email filter
- Logging and reporting
- Glossary
- Index