Fortinet FortiGate-800 - Manual (Page 251)

IPSec VPN IPSec VPN concentrators
FortiGate-800 Installation and Configuration Guide
251
See “Adding an encrypt policy” on page 247 .
5 Arrange the policies in the following order:
• encrypt policies
• default non-encrypt policy (Internal_All -> External_All)
Adding a VPN concentrator
To add a VPN concentrator configuration
1 Go to VPN > IPSec > Concentrator.
2 Select New to add a VPN concentrator.
3 Enter the name of the new concentrator in the Concentrator Name field.
4 To add tunnels to the VPN concentrator, select a VPN tunnel from the Available
Tunnels list and select the right arrow.
5 To remove tunnels from the VPN concentrator, select the tunnel in the Members list
and select the left arrow.
6 Select OK to add the VPN concentrator.
Figure 61: Adding a VPN concentrator
Source Internal_All
Destination The VPN spoke address.
Action ENCRYPT
VPN Tunnel The VPN spoke tunnel name.
Allow inbound Select allow inbound.
Allow outbound Select allow outbound
Inbound NAT
Select inbound NAT if required.
Outbound NAT Select outbound NAT if required.