Baseline Systems BaseStation 6000 - Manual (Page 72)

BaseStation 6000 Site Controller Manual
64 | P a g e
Clearing a Flow-Based Fault
When you notice a flow fault on your system, watering will not start again until you fix what is causing the fault, and then clear
the fault.
1. On the Main Page of the BaseStation 6000 software, click the Information tab to view the flow faults as illustrated below.
2. Click Clear Alarms and Alerts (1) .
3. Click one of the buttons in the Clear Error Warnings box.
• Yes clears all errors on all Remote Base Units.
• No clears the errors on the currently displayed Remote Base Unit.
• Cancel ignores the errors and returns to the Main Page.
4. Click the Diagnostics menu, and then click Flow Diagnostics. The Flow BiCoder and Pause Device Management and
Configuration window opens and displays the Flow Bicoder – All Bases tab.
5. Review the settings on the tab.
6. If any flow faults display in the pane at the bottom, click Reset to clear those faults. Watering will resume.
7. Click Return to close the Flow BiCoder and Pause Device Management and Configuration window.