Baseline Systems BaseStation 6000 - Manual (Page 19)

P a g e | 11
Identifying Your Site
Before you start configuring various hardware components in the BaseStation 6000 software, we recommend that you type the
name of your site in the Local Site Name (1) field at the bottom of the Main Page.
Configuring a Remote Base Unit
This section describes how to add a Remote Base Unit (RBU) to the BaseStation 6000 Site Controller. Each RBU manages an
electrically isolated irrigation sub-system and is able to support 200 valves.
Note: If your configuration includes a Bridge Unit and backbone wiring, you need to set up your computer and have the Bridge
Unit connected. Refer to Planning the Backbone Layout and Wiring Details on page 3 before adding a Remote Base Unit.
To configure an RBU
1. On the Main Page of the BaseStation 6000 software, click
the Base Unit (1) tab.
2. If the BaseStation 6000 site controller connects to the
RBU through a network, skip to Step 4. If the computer is
connected with a cable, continue with Step 3.
3. Click the Initialize Serial Ports (2) button. The Serial Port
Locator message box displays all available serial ports.
• If the list of serial ports and the default displayed in
the message box is correct, click Yes.
• If the serial port is not correct, click No. The Select
Alternate Port dialog box opens. Type the serial port
number in the field, and then click OK. If you need
help, consult with your IT department or call
Baseline Technical Support (866.294.5847).
4. On the Base Unit tab, click the Comm (3) button located
at the right end of the row for the first RBU.