beautypg.com

John Deere OMPC20964 User Manual

Page 99

background image

Original GreenStar Display—RTK

OUO6050,0000C40

–19–23SEP07–4/5

NOTE: Verify RAL has been deleted by viewing RAL list

(See Rover Access List section above).

RTK Vehicle Setup

Original GreenStar Display

Screen: SETUP – RTK StarFire iTC

Press: SETUP >> STARFIRE iTC >> DIFF
CORRECTION SETUP >> RTK SETUP >> VEHICLE

Original StarFire

Press: SETUP >> STARFIRE RECEIVER >> DIFF
CORRECTION SETUP >> RTK SETUP >> VEHICLE

NOTE: RTK vehicle can be operated in either Vehicle or

Vehicle Repeater Mode.

Enter the same RTK Network ID that the base station is
configured too.

RTK Vehicle Security Status

The RTK Vehicle (when operating off of a Secure Network
ID) will exist in one of the three following RTK
authorization states: Unknown, Authorized, or Not
Authorized.

These states are displayed in one or more of the following
locations depending on display and receiver used:
(Displayed on INFO – GPS – PAGE 3 (StarFire iTC) or
PAGE 5 (Original StarFire) or Cell G on GSD or on Cell G
of the Original GreenStar Monitor on a GS2 display).

Unknown – The RTK Vehicle StarFire upon power up is
in an “unknown” RTK authorization state. It will exist in
this state until communication with the base station is
established. No message will be displayed in cell G of the
GreenStar Display.

Authorized – On power-up of a RTK Vehicle StarFire that
is properly configured and on the authorization list , the
message “RTK Network: Authorized” will be displayed in
cell G as soon as it establishes communication with the
secure RTK base station and it determines that it is
authorized to receive RTK corrections.

30-11

121907

PN=99

Continued on next page