John Deere OMPC20964 - Manual (Page 75)

Original GreenStar Display—StarFire iTC
OUO6050,0002261 –19–14NOV06–1/1
Height—TCM
IMPORTANT: Under or over compensation for vehicle
roll angles will occur if height is
incorrectly entered during setup (i.e. on
a 10
° slope with a StarFire height error
of 12 inches will result in a position
offset of 2 inches on ground).
Factory default setting is “126”. On
some AutoTrac-equipped vehicles,
height value will be automatically
detected and entered during power up.
Because this dimension is critical for
proper operation of TCM and can vary
due to vehicle configuration and tire
sizes, operator should still measure
actual distance to be entered each time
TCM is installed on a different vehicle.
Height is measured from ground to top
of StarFire Dome.
NOTE: Use chart for example StarFire Height values.
Press letter button next to STARFIRE HEIGHT and enter
height using numeric keypad.
Press letter button next to STARFIRE HEIGHT again to
save number.
NOTE: Chart figures are approximate heights.
John Deere Vehicle StarFire Height cm (in.)
6000 Series Tractors 280 cm (111 in.)
7000 Series Tractors 305 cm (120 in.)
8000 Series Tractors 320 cm (126 in.)
8000T Series Tractors 320 cm (126 in.)
9000 Series Tractors 361 cm (142 in.)
9000T Series Tractors 356 cm (140 in.)
4700 Series Sprayers 389 cm (153 in.)
4900 Series Sprayers 396 cm (156 in.)
Combine 396 cm (156 in.)
25-16
121907
PN=75