Info pages, base station – John Deere OMPC20964 User Manual

Page 105

background image

Original GreenStar Display—RTK



INFO Pages, Base Station



Quick Survey



Absolute Survey

A—RTK Base Station Data


E—Signal Level

G—Software Version



Data Received

Serial Number

B—Satellite Corrections

D—Base Battery

F—Radio Connection

Location Number

Radio Data

Screen: INFO - GPS - PAGE 5

This screen allows operator to view:


– OK - Base Station is transmitting correction.
– No Stored Base - 24 hour self survey is required

for current location.

– Initializing - Receiver is initializing radio, acquiring

GPS signal.

– Self Survey - 24 hour self survey in progress.

Sat Corrections - Indicates number of GPS

satellites for which base station is transmitting

Distance - Difference between base station location

(known position) and location indicated by
uncorrected GPS.

Direction - Direction from base station location

(known position) to location indicated by uncorrected

Base Battery (volts) - Base Station voltage.

Signal Level - Level of signal that is detected at

radio. The signal level will range from 0 to 100 (-180
dBm to -80 dBm or above). Press E button to
refresh signal level.

NOTE: For Data Received (%): Value less than 100 %

indicates an obstruction between base station
radio and vehicle radio.

If percent of received correction is 0, and
signal level is high, check for potential radio
interference sources such as two-way radios,
radio towers, etc.

Data Received (%) - Percent of received correction

to base station from vehicle.

Radio Connection - Indicates source of correction.

If there is no connection, this will toggle between
base and repeater.

SW - Version of radio software

SN - Serial number of radio connected to receiver.