John Deere OMPC20964 - Manual (Page 49)

GS2 Display—RTK
OUO6050,0002251 –19–19NOV06–1/1
Quick Survey Mode
NOTE: Display is not required after base station
receiver has been configured to operate in
Quick Survey Mode and RTK Radio
Frequency, Network ID and Time Slot have
been set.
Connect display to base station
Press: MENU button >> STARFIRE ITC button >>
RTK softkey
Select Quick Survey Base from Operating Mode list
box.
NOTE: Quick Survey Base Mode allows base station
to broadcast corrections after receiver
calculates GPS position.
If power is removed from base station (but not moved)
power can be restored and same base station position
will be used for corrections. If previously used Track 0
is recalled, Shift Track may not be needed.
If power is removed and base station is moved a new
position will be calculated when power is restored. If
previously used Track 0 is recalled, Shift Track will
have to be used to center Track 0 on previous vehicle
track.
OUO6050,0000C23 –19–18OCT07–1/3
Absolute Base Mode
IMPORTANT: Absolute Base Mode requires base
receiver to be mounted in a rigid
position. Tripod is not
recommended.
NOTE: Display is not required after base station
receiver has been configured to operate in
Absolute Survey Base Mode and RTK Radio
Frequency, Network ID and Time Slot have
been set.
Connect Display to Base Station
Press: MENU >> STARFIRE ITC button >> RTK
softkey
Select Absolute Base from Operating Mode drop-down
box.
A 24-hour survey has to be performed and saved to a
RTK Base Location (1-200). See Edit Stored Base
Station Section.
Continued on next page
20-6
121907
PN=49