John Deere OMPC20964 User Manual
Page 142
![background image](/manuals/132814/142/background.png)
Troubleshooting and Diagnostics
OUO6050,0002236
–19–25NOV06–3/5
Control Unit
Add.
Description
Details
iTC
035
DISPLAY/MODIFY: Distance from pivot point of
Shown in cm.
vehicle to center of receiver.
Range -508 to +508
iTC
036
DISPLAY/MODIFY: Direction that receiver faces
0 = Backward
during normal operation
1 = Forward
iTC
037
DISPLAY/MODIFY: RTK search algorithm status
0 = Off
1 = vehicle
2 = vehicle/repeater
3 = base station (quick survey)
4 = base station (absolute base)
iTC
038
DISPLAY/MODIFY: Current StarFire corrections
0 = differential corrections turned off
being used.
1 = SF1 mode
2 = SF2 mode
iTC
039
DISPLAY/MODIFY: Frequency that StarFire
Shown in kilohertz
corrections are received on.
1525000
1560000
iTC
040
DISPLAY/MODIFY: Status of WAAS/EGNOS
0 = WAAS/EGNOS differential corrections are not
correction signal
being used.
1 = WAAS/EGNOS differential corrections are being
used.
iTC
041
DISPLAY/MODIFY: Serial port transmission rate.
Shown as RS232 baud rate.
4800
9600
19200
38400
iTC
042
DISPLAY/MODIFY: Serial port message frequency.
Shown in Hertz.
1 or 5
iTC
043
DISPLAY/MODIFY: GGA Output Status
0 = Off
1 = On
iTC
44
DISPLAY/MODIFY: GSA Output Status
0 = Off
1 = On
iTC
045
DISPLAY/MODIFY: RMC Output Status
0 = Off
1 = On
iTC
046
DISPLAY/MODIFY: VTG Output Status
0 = Off
1 = On
iTC
047
DISPLAY: ZDA Output Status
0 = Off
1 = On
iTC
048
DISPLAY: Output of TCM accelerometer raw signal.
Shown in per cent
iTC
049
DISPLAY: Output of TCM accelerometer
Shown as one thousandth of acceleration due to
gravity
iTC
053
DISPLAY: Operating temperature of TCM
Shown in degrees Centigrade
accelerometer component.
iTC
054
DISPLAY: Latitude as calculated by receiver
Shown in degrees
iTC
055
DISPLAY: Longitude as calculated by receiver
Shown in degrees
iTC
057
DISPLAY: Course as calculated by GPS receiver.
Shown in degrees
iTC
058
DISPLAY: Calibration value of TCM unit on flat
surface.
40-6
121907
PN=142
Continued on next page