# Info - gps - page 2 – John Deere OMPC20964 User Manual

## Page 82

*Original GreenStar Display—StarFire iTC*

OUO6050,0002267

–19–14NOV06–1/1

**INFO - GPS - PAGE 2**

**7**

**4**

**1**

**0**

**5**

**2**

**9**

**6**

**3**

**.**

**8**

**CLR**

**SETUP**

**PAGE**

**RUN**

**INFO**

**JOHN DEERE**

**A**

**B**

**C**

**D**

**E**

**F**

**G**

**GPS**

**DiagnosticTrouble Codes**

**INFO**

**PAGE 2**

**Data Log(Diagnostic Use Only)**

**Freq (MHz)Corrections Age(sec)**

**1545.5450**

**0**

**Sats above Elev MaskSatellites Tracked**

**00**

**Sats in SolutionPDOP**

**0**

**0.0**

**Roll Angle**

**-15.5˚**

**Yaw Rate**

**+30 deg/s**

PC9566

–UN–06NOV06

*INFO - GPS - PAGE 2*

**A—Diagnostic Trouble CodesB—Data Log (Diagnostic Use Only)C—FrequencyCorrections AgeD—Satellites above Elevation MaskSatellites TrackedE—Satellites in SolutionPDOPF—Roll AngleG—Yaw Rate**

**Screen: **INFO - GPS - PAGE 2

**Press: **INFO >> STARFIRE RECEIVER >> PAGE

**Diagnostic Trouble Codes: **(See DIAGNOSTIC

TROUBLE CODES in Troubleshooting section.)

**Data Log: **Three data log pages consist of graphs

showing GPS information for up to previous 60 minutes.

Graphs can be used to show user any variation that has

occurred in last 60 minutes.

**Freq (MHz): **This cell shows frequency of differential

correction signal that receiver is set to receive.

**Corrections Age (SEC): **This cell shows age of

differential correction signal to GPS (normally less than 10

seconds).

**Sats Above Elev Mask: **This is total number of GPS

satellites available to your receiver that are above 7

°

elevation mask.

**Satellites Tracked: **This is total number of GPS satellites

tracked by your receiver.

**Satellites in Solution: **This cell shows number of

satellites actively used to compute position.

**PDOP: **PDOP (Position Dilution of Precision) is an

indicator of GPS satellite geometry as viewed by receiver.

A lower PDOP indicates better satellite geometry for

calculating both a horizontal and vertical position.

**Roll Angle: **Is both graphical and numerical

representation of amount of roll TCM is measuring,

relative to calibrated zero degree reference. A positive roll

angle means vehicle is rolled to right.

**Yaw Rate: **This gives a graphic representation and a

numeric figure for amount of rotation TCM is measuring.

Positive yaw rate means vehicle is turning to right.

**25-23**

121907

PN=82