HP LC 2000 - Manual (Page 99)

Chapter 8 Rack-Mounting the HP NetServer
91
Figure 8-10. Pressing in the Release Latches
14. Verify the NetServer will slide all the way into the rack, before continuing
with the procedures.
15. Continue with the next section, "Attaching the Cable Management Arm,"
before securing the HP NetServer in the rack.
Attaching the Cable Management Arm
Use this procedure to mount the Cable Management Arm on the HP NetServer
LC 2000r when mounted in the HP System/E or System /U racks. The HP
NetServer LC 2000r’s Cable Management Arm allows the cables, including the
power cord, to move in and out with the HP NetServer chassis without any
damage or being accidentally disconnected. See Figure 8-11.