beautypg.com

Installing non-hot swap storage devices – HP LC 2000 User Manual

Page 59

background image

Chapter 4

Installing Mass Storage Devices

51

Installing Non-Hot Swap Storage Devices

Use this section to install any of the non-hot swap mass storage devices used as a
hard drive or a tape backup storage.

CAUTION

Protect the drive from static electricity by leaving it in its
anti-static bag until you are ready to install it. Before handling
the drive, touch any unpainted metal surface to discharge
static electricity. When you remove the drive from the
anti-static bag, handle it only by the frame.

Do not touch the electrical components. Place the drive on the
anti-static bag whenever you set it down.

Non-Hot Swap
Drives
(Optional)

Figure 4-13. Non-Hot Swap Drive Shelves

To install a drive in the non-hot swap drive bay, refer to the following procedure.

1. If necessary, shutdown the HP NetServer’s NOS.

Refer to Chapter 2, "Controls, Ports, and Indicators."

2. Disconnect all telephone cables and power cords.

This manual is related to the following products: