HP LC 2000 - Manual (Page 111)

Chapter 10 Configuring the HP NetServer
103
Running Configuration Assistant and Installation
Assistant
Insert the HP NetServer Navigator CD-ROM into the CD-ROM drive. Turn the
power off, wait 10 seconds, and turn the power on again. If the system fails to
start, follow the instructions on the screen.
1. You may need to set the language, time, and date when the HP NetServer
Navigator starts.
2. If this is true, follow the onscreen instructions.
You can also change the language in which BIOS error messages are
reported, but this is only available when in the Setup Utility (BIOS).
3. Go to the HP NetServer Navigator main menu and select Configuration
Assistant and Installation Assistant.
4. Follow the on-screen instructions in Configuration Assistant to continue
the NetServer installation.
Express Configuration
Express configuration is the preferred method to configure your NetServer since it
leads you through the configuration process in sequence and offers you default
selections. Express configuration includes the following steps:
•
Update System BIOS:
This step appears if Configuration Assistant detects a newer version of the
BIOS is available on the HP NetServer Navigator CD-ROM. You must
update your BIOS to the new version if you want to continue in Express
mode. You can also change the language the BIOS displays.
•
Select NOS:
You will be asked to select the NOS and version you plan to install.
•
Select NOS Installation Mode:
For certain versions of Novell NetWare/IntranetWare and Microsoft
Windows NT Server, you will be asked;
Would you like to use HP’s automated mode of
NOS installation?
◊ Select Yes for automated NOS installation.