HP LC 2000 - Manual (Page 110)

Chapter 10 Configuring the HP NetServer
102
The CD-ROM will start automatically using the auto-run feature as soon as
the drive closes.
NOTE Using the low profile CD-ROM drive is slightly different than
full-height units. The disk drawer will spring out only part way
when you push the eject button. You must manually pull the
drawer open and manually close it after inserting a CD-ROM.
4. If the CD-ROM does not start automatically, push the reset button.
5. If the system fails to boot, follow the diagnostic instructions on the screen.
6. Go to the HP Navigator main menu.
7. If the language needs to be changed, select User Preferences and the
language you want.
You can also change the language of the BIOS, but this is only available
when in the BIOS Setup Utility.
8. Select Readme File and read it carefully before beginning your
installation.
The Readme file contains the latest information to help you install your HP
NetServer.
Configuration Assistant
Configuration Assistant guides you through the steps necessary to configure the
HP NetServer. You can view configuration advisories at one step and change your
hardware if necessary.
HP Configuration Assistant and Installation Assistant guide you through the steps
necessary to configure the NetServer. Three methods of configuration are
available: Express, Custom, and Replicate.
HP Installation Assistant guides you through the NOS installation and configures
the NOS with the appropriate drivers for the HP-bundled configuration. If
Configuration Assistant detects that a newer version of the BIOS is available on
the HP Navigator CD-ROM it will prompt you to update the BIOS.
Before you run Configuration Assistant and Installation Assistant, you may need
to run the Symbios Configuration utility and the Setup Utility to do the following:
•
If you need to verify or modify SCSI host adapter settings.
l If you need to low-level format SCSI disks or verify SCSI disk media, run
the Symbios Configuration utility.