HP LC 2000 - Manual (Page 63)

55
5 Installing Additional Memory
Introduction
This chapter provides the instructions for installing and removing DIMMs on the
system board in the HP NetServer LC 2000 or LC 2000r. The video memory
comes with 2MB standard and cannot be upgraded.
NOTE The EDO DIMMs and PC 100 SDRAM DIMMs from earlier
HP NetServer models will fit into the DIMM slots in the
NetServer LC 2000/LC 2000r, but the EDO DIMMs and PC
100 SDRAM will not function properly. Use only 133 MHz
SDRAM DIMMs acquired from HP.
To ensure you have the correct DIMMs before installation, refer to one of the
following for a list of qualified DIMMs:
•
Technical Reference Label inside the HP NetServer’s top or side cover
•
HP Order Assistant on the HP web site at:
http://www.hp.com/go/netserver
•
Information Assistant on the HP NetServer Online Documentation
CD-ROM
•
HP Customer Service
Tools Required
l An anti-static service kit (3M™ 8501/8502/8503 or equivalent). This kit
includes a static-dissipating work surface, a chassis clip lead, and a wrist
strap.