HP LC 2000 - Manual (Page 18)

Chapter 2 Controls, Ports, and Indicators
10
Power, Reset, and Keyboard Lock Buttons
The control buttons shown in Figures 2-1 and 2-2 are described in the Table 2-1.
Table 2-1. Power, Reset, and Keyboard Lock Buttons and LEDs
Control/LED Description
Power On/Off/
Sleep Button
This button turns the HP NetServer power On or Off, and if
available, also transitions the NetServer between Power On
and sleep states. If sleep states are not available, then this
button only turns power On or Off.
The sleep states are NOS dependent and not available if your
NOS does not support power management based on the ACPI
(Advanced Configuration and Power Interface) standard.
Refer to "Applying Power to the HP NetServer" and "Sleep
States (ACPI)" later in this chapter.
Power On/Off/
Sleep LED
This LED glows steady green when power is on, and goes
dark when the NetServer is powered off.
If the NetServer is under ACPI control, this LED will flash
green on and off when in an inactive sleep state.
Reset Button
RESET
Performs a system (hard) reset.
Keyboard
Lock Button
Puts the NetServer in a locked mode, which locks the
keyboard, if the NetServer was configured for keyboard lock
or Network Server mode in the Setup Utility.
This includes keyboard lock, power button lock, and video
blanking. The reset button is also disabled.
Keyboard
Lock LED
This LED glows solid green when the HP NetServer’s
keyboard is locked, and is dark at all other times.