HP LC 2000 - Manual (Page 64)

Chapter 5 Installing Additional Memory
56
Memory Installation Guidelines
•
The HP NetServer LC 2000/2000r uses only 133 MHz (PC133) SDRAM
DIMMs, which are electrically different from the EDO and PC100
SDRAM memory modules used in previous HP NetServer models.
•
DIMM sizes supported are 64 MB, 128 MB, 256 MB, 512 MB, or 1 GB in
any combination.
•
Supported memory capacity ranges from 64 MB to 4 GB maximum (1 GB
per DIMM slot and 4 DIMM slots total). The minimum capacity is 64 MB
(one DIMM).
•
DIMM sizes may be mixed on the system board and may be loaded in any
order (0 through 3).
•
Open slots between DIMMs are permitted.
•
When handling DIMMs, observe anti-static precautions to avoid damage.
DIMM Installation
Use this procedure to install each DIMM in a DIMM slot on the system board.
Figure 5-1. Individual SDRAM DIMM
CAUTION Do not install EDO DIMMs or PC100 SDRAM from previous
HP NetServers in the HP NetServer LC 2000/2000r. Use only
DIMMs specified for the HP NetServer LC 2000/2000r.