HP 4100TN User Manual
Page 66
64 Chapter 2 - Printing tasks
EN
Note
Settings in the printer driver and software application override control
panel settings. (Software application settings generally override printer
driver settings.)
If the settings are not available from the software, set the custom
paper size from the control panel:
1
From the Printing Menu set
CONFIGURE CUSTOM PAPER=YES
.
2
From the Printing Menu, select inches or millimeters as the unit of
measurement.
3
From the Printing Menu, set the X dimension (the front edge of
the paper) as shown in the figure above. The X dimension can be
76 to 216 mm (3 to 8.5 in).
4
Set the Y dimension (the side edge of the paper) as shown in the
figure above. The Y dimension can be 127 to 356 mm (5 to 14 in).
For example, if the custom paper is 203 by 254 mm (8 by 10 in),
set X=203 mm and Y=254.
5
If custom paper is loaded into tray 1, set
TRAY 1 MODE=CASSETTE
and then set
TRAY 1 SIZE=CUSTOM
from the Paper Handling
Menu in the printer control panel. See “Customizing tray 1
operation” on page 69.
If custom paper is loaded in tray 2, 3, or 4, be sure the paper size
slider is set to Custom (see “Loading trays 2, 3, and 4” on
page 47).
X (front edge)
Y (side edge)
Feed short
edge first