beautypg.com

Labels, Transparencies, Labels transparencies – HP 4100TN User Manual

Page 198: Label construction

background image

196 Appendix A - Specifications

EN

Labels

CAUTION

To avoid damaging the printer, use only labels recommended for use
in laser printers.

If you have problems printing labels, use tray 1 and open the rear output
bin.

Do not print on the same sheet of labels more than once—peeling and
adhesive contamination might result.

Label construction

When selecting labels, consider the quality of each component:

Adhesives: The adhesive material should be stable at 230° C
(446° F), the printer’s maximum temperature.

Arrangement: Only use labels with no exposed backing between
them. Labels can peel off sheets with spaces between the labels,
causing serious jams.

Curl: Prior to printing, labels must lie flat with no more than
13 mm (0.5 in) of curl in any direction.

Condition: Do not use labels with wrinkles, bubbles, or other
indications of separation.

To print sheets of labels, see “Printing labels” on page 61.

Transparencies

Transparencies used in the printer must be able to withstand 230° C
(446° F), the printer’s maximum temperature. Close the rear output
bin to print transparencies to the top output bin.

If you have problems printing transparencies, use tray 1. Be sure to
remove each transparency from the output tray to keep them from
sticking together.

CAUTION

To avoid damaging the printer, use only transparencies recommended
for use in laser printers.

To print transparencies, see “Printing transparencies” on page 62.

This manual is related to the following products: