Loose toner, Repeating defects, Loose toner repeating defects – HP 4100TN User Manual
Page 135
EN
Correcting output quality problems 133
Loose toner
Loose toner, in this context, is defined as toner that can be rubbed off
the page.
1
If paper is heavy or rough, try using a high fuser mode so that
toner fuses more completely onto the paper. At the printer control
panel, use
CONFIGURE FUSER MODE MENU
in the Paper Handling
Menu. To do this (see “Paper Handling Menu” on page 210).
2
If you have observed a rougher texture on one side of your paper,
try printing on the non-rough side.
3
Make sure that the environmental specifications for the printer are
being met (see “Printer specifications” on page 200).
4
Make sure that paper type and quality meet HP specifications
(see “Paper specifications” on page 188).
5
Maintenance might be due. Check this by printing a copy of the
supplies status page (see “Supplies status page” on page 154). If
maintenance is due, order and install the printer maintenance kit
(see “Performing preventative maintenance” on page 93).
Repeating defects
See also “Repeating image” on page 134.
1
Print a few more pages to see if the problem corrects itself.
2
If the distance between defects is 38 mm (1.5 in) or 94 mm
(3.76 in), the toner cartridge might need to be replaced.
3
Clean the inside of the printer (see “Cleaning the printer”
on page 88) and run a manual cleaning page to clean the fuser
(see “Running the cleaning page manually” on page 91).
4
Maintenance might be due. Check this by printing a copy of the
supplies status page (see “Supplies status page” on page 154). If
maintenance is due, order and install the printer maintenance kit
(see “Performing preventative maintenance” on page 93).