Olympus OM-D E-M1 Mark III Mirrorless Camera - Manual (Page 78)

78 EN
Shooting
2
Performing the sequential/self-timer shooting
Adjust settings for burst or self-timer photography. Choose an option according to your
subject. Other options, including anti-shock and silent modes, are also available.
1 Press the j Y# button.
2 Rotate the rear dial to select a value.
• Custom self-timer options can be viewed by pressing the INFO button.
o Single
Single-frame advance. The camera takes one photo each
time the shutter button is pressed all the way down.
T Sequential High
The camera takes photos at up to about 15 fps while the
shutter button is held all the way down. Focus, exposure,
and white balance are locked at the values for the
fi rst shot
in each series. You can choose the frame advance rate and
the maximum number of shots in each series (P. 220). The
frame advance rate drops at [
K ISO] settings over 8000.
S Sequential Low
The camera takes photos at up to about 10 fps while the
shutter button is held all the way down. You can choose
the frame advance rate and the maximum number of shots
in each series (P. 220). Focus and exposure conform to
the options selected for [
K AF Mode] (P. 64, 91) and
[ K AEL/AFL] (P. 201). If [C-AF], [C-AF b ], [C-AF+TR],
or [C-AF+TR b ] is selected for [ K AF Mode], the camera
will focus before each shot. The frame advance rate drops at
[
K ISO] settings over 8000.
X Y 12sec
The shutter is released 12 seconds after the shutter button
is pressed all the way down. The self-timer lamp will light for
about 10 seconds and then start to
fl ash about 2 seconds
before the shutter is released. The camera focuses when the
shutter button is pressed halfway.
Z Y 2sec
When the shutter button is pressed all the way down, the
self-timer lamp will start to
fl ash and a photo will be taken
after about 2 seconds. The camera focuses when the shutter
button is pressed halfway.
c
Custom
Self-Timer Adjust self-timer settings, including the self-timer delay and
the number of shots taken when the timer expires (P. 80).
♦ S
(sample
icon)
Anti-Shock r
Reduce the slight blur caused by shutter motion (P. 80).
Available in single-frame, sequential low, and self-timer
modes.