beautypg.com

Information, The number of af targets is reduced, The date and time has not been set – Olympus OM-D E-M1 Mark III Mirrorless Camera User Manual

Page 297: Image taken appears whitish, Functions that cannot be selected from menus

background image

297

EN

Information

7

Noise reduction is activated

• When shooting night scenes, shutter speeds are slower and noise tends to appear in

images. The camera activates the noise-reduction process after shooting at slow shutter
speeds. During which, shooting is not allowed. You can set [Noise Reduct.] to [Off].

g

G

Custom Menu

T

> [Noise Reduct.] (P. 192)

The number of AF targets is reduced

The size and number of the AF target changes depending on the [Digital Tele-converter]
(P. 143), [Aspect] (P. 98), and group target (P. 69) settings.

The date and time has not been set

The camera is used with the settings at the time of purchase

• The date and time of the camera is not set when purchased. Set the date and time before

using the camera.

g

“Initial setup” (P. 33)

The battery has been removed from the camera

• The date and time settings will be returned to the factory default settings if the camera is

left without the battery for approximately 1 day (in-house measurements). The settings
will be canceled more quickly if the battery was only loaded in the camera for a short time
before being removed. Before taking important pictures, check that the date and time
settings are correct.

Set functions are restored to their factory default settings

Settings adjusted in custom modes (modes

C1

C4

) will be reset to saved values when

another shooting mode is selected or the camera is turned off. If [Hold] is selected for [Reset/
Custom Modes] > [Custom Mode Save Settings] in

W

Shooting Menu 1 when a custom

mode is selected, changes to settings will automatically be saved to the selected mode.

g

“Updating Custom Modes Automatically” (P. 57)

Image taken appears whitish

This may occur when the picture is taken in backlight or semi-backlight conditions. This is
due to a phenomenon called

fl

are or ghosting. As far as possible, consider a composition

where strong light source is not taken in the picture. Flare may occur even when a light
source is not present in the picture. Use a lens hood to shade the lens from the light
source. If a lens hood does not have effect, use your hand to shade the lens from the light.

g

“Interchangeable lenses” (P. 285)

Unknown bright dot(s) appear on the subject in the picture taken

This may be due to stuck pixel(s) on the image pickup device. Perform [Pixel Mapping].
If the problem persists, repeat pixel mapping a few times.

g

“Pixel Mapping - Checking the

image processing functions” (P. 295)

Functions that cannot be selected from menus

Some items may not be selectable from the menus when using the arrow pad.

• Items that cannot be set with the current shooting mode.
• Items that cannot be set because of an item that has already been set:

Combinations of [

T

] (P. 78) and [Noise Reduct.] (P. 192), etc.