KEPCO KLP Series User Manual, Rev 4 - Manual (Page 71)

KLP091313
3-29
• The OPERATE INSTRUMENT password restricts the ability to modify the OPERATE
INSTRUMENT page settings. The settings can still be viewed while password protected
• The CONFIGURE INSTRUMENT password restricts the ability to change some
INSTRUMENT configuration parameters shown on the CONFIGURE INSTRUMENT
page.
• The CONFIGURE LAN password restricts the ability to change the LAN configuration
parameters shown on the CONFIGURE LAN page (Figure 3-6.)
FIGURE 3-6. WEB INTERFACE CONFIGURE LAN PAGE
The factory default is that passwords are not needed to access password-protected areas and
none of the three passwords are established. To set a password for the first time, leave the
CURRENT field blank, enter the new password in the NEW and REPEAT fields, then click SUB-
MIT. Subsequent changes require the current password to be entered in the CURRENT field. If
a password is lost or forgotten, the factory default state (no password required) can be restored
from the front panel using the LAN Reset function (see PAR. 3.2.15).
To change a parameter, enter the correct data and/or click the appropriate checkboxes, then
click SUBM IT to save the change or NO CHANGE to clear and reload the page without saving.
If the data is not entered within 20 seconds after the last keystroke, the data will revert to the
previous value. If the LAN CONFIGURATION password was set, you will be prompted to enter
the password before the changes are accepted.