Table 1-5. accessories, Table 1-6. safety symbols, Accessories -13 – KEPCO KLP Series User Manual, Rev 4 User Manual
Page 25: Safety symbols -13, E 1-5. loa
KLP 091313
1-13/1-14 Blank)
TABLE 1-5. ACCESSORIES
ITEM
FUNCTION
KEPCO
PART NUMBER
Line Cord Set (125V/20A)
2.5m long cord set, provides for source power
connection. Mates with NEMA 5-20R receptacle
(see adjacent figure). Supports rated load power
over mains voltage range of 100-136V a-c.
NEMA 5-20R
118-0776
Line Cord Set (125V/15A)
2.5m long cord set, provides for source power
connection. Mates with NEMA 5-15R receptacle
(see adjacent figure). Supports restricted load
power over mains voltage range of 100-136V a-c
(contact Kepco Sales Engineering for details).
NEMA 5-15R
118-1136
Line Cord Set (250V/15A)
2.5m long cord set, provides for source power
connection. Mates with NEMA 6-15R receptacle
(see adjacent figure). Supports rated load power
over mains voltage range of 180-265V a-c.
NEMA 6-15R
118-1137
Source power connector
Mates with a-c input connector J1 (see Figure 1-2). Allows user to
fabricate custom line cord.
142-0381
IEEE 488 (GPIB) Cable, 1m long
Connect KLP Power Supply to GPIB bus.
SNC 488-1
IEEE 488 (GPIB) Cable, 2m long
Connect KLP Power Supply to GPIB bus.
SNC 488-2
IEEE 488 (GPIB) Cable, 4m long
Connect KLP Power Supply to GPIB bus.
SNC 488-4
Chassis Slide (2 required per
power supply)
Allows rack-mounted units to slide in and out.
108-0239
(Jonathan
375-QD Series)
Analog Connector Backshell
Locks analog port mating connector to KLP via jackscrews.
108-0204
Loop Back Test Connector
Used for verification of RS 232 operation.
195-0112
Null Modem Cable, 10 ft.
Connect RS 232 port with controlling computer, DB9F to DB9F, 10 feet
long.
118-1176
Null Modem Cable, 1 ft.
Used for Master/Slave connections. Connects RS 232 ports of stacked
power supplies, DB9F to DB9F, one foot long.
118-1220
LAN Patch cable
Connects KLP LAN port to LAN, 10 ft long.
118-1115
Support bracket, rear
Provides extra support to rear of rack-mounted unit if needed. Two
brackets required per unit. Each bracket requires 2 screws and 2
washers. See Figure 1-3, sheet 1, Detail “A” for requirements.
128-2306
TABLE 1-6. SAFETY SYMBOLS
SYMBOL
MEANING
CAUTION: RISK OF ELECTRIC SHOCK.
CAUTION: REFER TO REFERENCED PROCEDURE.
WARNING
INDICATES THE POSSIBILITY OF BODILY INJURY OR DEATH.
CAUTION
INDICATES THE POSSIBILITY OF EQUIPMENT DAMAGE.
!