KEPCO KLP Series User Manual, Rev 4 - Manual (Page 16)

1-4
KLP 091313
TABLE 1-3. KLP SPECIFICATIONS
SPECIFICATION RATING/DESCRIPTION CONDITION/COMMENT
INPUT CHARACTERISTICS
a-c voltage(1)
nominal 100-240 Va-c Single Phase.
range 90-265 Va-c Wide Range; contact factory for opera-
tion to 265V a-c.
Frequency
nominal range 50-60 Hz
maximum 45-440 Hz Increased Leakage above 66 Hz.
Power Factor typical 0.99 Meets EN 61000-3-2.
Maximum Input Current 120 Va-c 13A rms Rated load (1200W).
240 Va-c 6.5A rms Rated load (1200W).
Inrush Current
265 Va-c 40A Peak
132 Va-c 20A Peak
Input Fusing Circuit Breaker 2-line
Low a-c Protection 87V a-c, Self protected
Output hold up typical 10 milliseconds Ride through.
Leakage Current 115 Va-c, 60Hz 1.2mA max
230 Va-c 50Hz 2.3mA max
Electromagnetic
compatibility Emissions CISPR11, Class A Class B Conducted
Immunity EN 61326-1, Table 2 Industrial Environment
OUTPUT CHARACTERISTICS
Type of stabilizer CV/CC Voltage/Current
Adjustment range voltage 0-100% of rated voltage No minimum load required.
current minimum to 100% of rated current No minimum load required. See Table
1-2 for minimum programmable current.
Source effect voltage 0.01% Emax Over full source range.
current 0.01% Imax
Load effect voltage 0.02% Emax Over full load range.
current 0.05% Imax
Temperature effect voltage 0.01%/deg C 0-50 deg C
current 0.01%/deg C
Time effect (drift) voltage 0.02%/24hr After 30 min warmup.
current 0.02%/24hr
Error sensing 0.25 volts per wire Above rated output. Contact factory for
larger margins.
Isolation voltage 600 Vd-c or peak
(100V for 10V, 20V and 36V models)
Either output terminal to ground.
(1) Contact factory for details on operation from d-c input.