KEPCO KLP Series User Manual, Rev 4 - Manual (Page 19)

KLP 091313
1-7
PROGRAMMING CHARACTERISTICS - ANALOG
Analog remote control selection Activate with jumper at analog program-
ming connector
Recognized during power up.
isolation Safety Extra Low Voltage (SELV)
Analog Input Update Rate 2Hz (0.5 Second) Applies to program-
ming by voltage/ resistance and read-
back specifications. Analog input voltage digitized (12-bit
resolution), optically isolated, then pro-
cessed by digital section.
Programming by voltage voltage 0-10V See PAR. 4.3.3 to reduce Full Scale
voltage.
current 0-10V Min. programming limit; see Table 1-2.
See PAR. 4.3.3 to reduce Full Scale
voltage.
Programming by resistance voltage 0-10K ohms See PAR. 4.3.3 to reduce Full Scale
resistance.
current 0-10K ohms Min. programming limit; see Table 1-2.
See PAR. 4.3.3 to reduce Full Scale
resistance.
Readback 0-10V proportional signal Proportional to analog control volt-
age/resistance.
Remote inhibit TTL compatible Dual polarity; see PAR. 3.2.17.3.1.
Composite status flag Isolated form C contacts Programmable functions (PAR.
3.2.17.1).
PROGRAMMING CHARACTERISTICS - DIGITAL
Supported Interfaces standard models GPIB and RS 232 SCPI command set for GPIB and RS
232 (see KLP Developer’s Guide).
E-Series models GPIB and LAN Support SCPI command set (see KLP
Developer’s Guide) for GPIB and LAN;
Support four interfaces for LAN:
1. Web interface, port 80 (LXI Class C,
Version 1.2
2. SCPI Telnet, port 5024
3. SCPI Sockets, port 5025
4. VXI 11, port 1024
GPIB GPIB address range: 1 to 30 Factory default is 6.
RS 232 standard models Baud Rate range: 2400, 4800, 9600,
19,200 or 38,400
Factory default is 38,400.
Digital remote control isolation Safety Extra Low Voltage (SELV)
format compatible with SCPI protocols W98 SE and later operating systems.
Programming resolution 0.024% of Emax and Imax
Programming accuracy 0.05% of Emax and Imax
Readback resolution 0.024% of Emax and Imax
Readback accuracy Either 0.1% of Emax and Imax, or front
panel voltmeter or ammeter display res-
olution, whichever is greater.(1) ±1 LSB error
Status reporting OVP, OCP, OTP, output lead fault
(OLF), fan failure, power loss See PAR. 1.5.4 and 1.5.9.
(1) Display resolution is determined by the number of significant digits shown, relative to the decimal point. Resolution is 10-X where
X is the number of digits to the right of the decimal point. E.g for display of 10.00V, resolution is 10-2 or 0.01 or 10mV; for display of
150.0A, resolution is 10-1 or 0.1 or 100mA.
TABLE 1-3. KLP SPECIFICATIONS (Continued)
SPECIFICATION RATING/DESCRIPTION CONDITION/COMMENT