KEPCO KLP Series User Manual, Rev 4 - Manual (Page 70)

3-28
KLP091313
Once the configuration has been altered by changing the applicable fields, click SUBMIT to
save the new configuration, or NO CHANGE to clear and reload the page without saving (NO
CHANGE is the same as browser refresh or reload).
NOTE: When the SUBMIT button is clicked, only one changed line is processed. If multiple
configuration changes are entered, lines are processed in sequence from top to bot-
tom, and multiple presses of SUBMIT are needed to process all the changes. If a previ-
ously changed line is altered again, it will be processed first.
FIGURE 3-5. WEB INTERFACE CONFIGURE INSTRUMENT PAGE
3.3.6.5 LAN CONFIGURATION USING WEB INTERFACE [E-SERIES MODELS ONLY]
Click on CONFIGURE LAN at the left to view the LAN Configuration page (Figure 3-6). The
parameters that can be configured from this page are Host Name (DHCP), Description, IP
Address, Subnet Mask address, Default Gateway Address, and DNS Server Address. Separate
checkboxes allow enabling of DHCP, AUTOIP and PING. Descriptions of these terms can be
viewed by clicking the HELP box at the left. If a data entry fault condition exists, an alert window
indicates the type of fault. Click OK to close the window; the SUBMIT button is disabled until the
fault is corrected.
There are three passwords shown on this page which control access to the web pages only (not
to be confused with the unit password (see PAR. 3.2.8) which is needed for calibration, chang-
ing virtual model, etc.). All three web passwords described below are case sensitive.
NOTE: In cases where multiple users are expected to have access to the units, it is recom-
mended that password access be used to restrict control of the unit to one user (func-
tioning as a bus controller), while allowing other users viewing access. Allowing
multiple users to issue commands to a single unit can cause unpredictable results and
may cause the unit to lock up.