KEPCO KLP Series User Manual, Rev 4 User Manual
Page 57
KLP091313
3-15
• DHCP - DHCP status is displayed in the DC VOLTS display. To change the setting press
DC OUTPUT switch, then rotate either VOLTAGE or CURRENT control to see desired
setting and press DC OUTPUT switch to save.
•
ON - The KLP requests an IP address from the DHCP server. (AUTOIP set to
OFF.)
•
OFF - The KLP uses the IP, MASK, GATE and DNS addresses established by
the user using either the UTIL - LAN menus at the front panel, the web interface
(see PAR. 3.3.6) or via SCPI commands over one of the digital interfaces.
(AUTO IP also set to OFF.)
• AUTO - AUTO IP status is displayed in the DC VOLTS display.
•
ON - The KLP obtains an IP address automatically. (Both DHCP and AUTO IP
set to ON.)
•
OFF - The KLP uses the IP, MASK, GATE and DNS addresses established by
the user using either the UTIL - LAN menus at the front panel or via SCPI com-
mands. (AUTOIP set to OFF.)
• MAC1 - Shows first pair of hex digits of the MAC address (e.g., for MAC address 01-23-
45-67-89-AB the DC VOLTS display shows 01- and the DC AMPERES display shows
23-). Cannot be changed by the user.
• MAC2 - Shows second of two hex digits of the MAC address (e.g., for MAC address 01-
23-45-67-89-AB the DC VOLTS display shows 45- and the DC AMPERES display
shows 67-). Cannot be changed by the user.
• MAC3 - Shows third pair of hex digits of the MAC address (e.g., for MAC address 01-23-
45-67-89-AB the DC VOLTS display shows 89- and the DC AMPERES display shows
AB). Cannot be changed by the user.
• IP1 - Shows first half of IP address (e.g., for IP address 192.168.000.200 the DC
VOLTS display shows 192._ and the DC AMPERES display shows 168._). To change
the address, press DC OUTPUT switch, then rotate VOLTAGE control to change 192._
or CURRENT control to change 168._, then press DC OUTPUT switch to save.
• IP2 - Shows second half of IP address (e.g., for IP address 192.168.000.200 the DC
VOLTS display shows _000. and the DC AMPERES display shows _200). To change
the address, press DC OUTPUT switch, then rotate VOLTAGE control to change _000.
or CURRENT control to change _200., then press DC OUTPUT switch to save.
• MSK1 - Shows first half of SUBNET MASK address (see IP1 described above). Default is
255.255.
• MSK2 - Shows second half of SUBNET MASK address (see IP2 described above).
Default is 0.0
• GTE1 - Shows first half of GATE address (see IP1 described above).
• GTE2 - Shows second half of GATE address (see IP2 described above).
• DNS1 - Shows first half of DNS address (see IP2 described above).
• DNS2 - Shows second half of DNS address (see IP2 described above).
• RTN - Return to LAN menu.