RIGOL DG4000 Series - Manual (Page 92)

RIGOL Chapter 3 Arbitrary Waveform Output
DG4000 Series User’s Guide 3-16
2) Press Excute to apply the setting defined in step 1). The waveform editor
will automatically use straight lines to connect the start point (point 2, the
level is 4 V) with the stop point (point 4, the level is -2 V) and
automatically generate point 1 and point 3 to create a continuous
waveform.
3) After finishing editing all the points, press to return to the previous
menu. At this point, press Save to enter the file storage interface (refer to
Store and Recall) to save the edited arbitrary waveform.
7. View the edited waveform.
V
μs
4
2
0
-2
4 8 12
2
1
3
4
Note: As can be seen from the above figure, after the start point (point 2) and
stop point (point 4) are inserted numerical values in the current interpolation
method, the waveform editor will automatically generate point 1 and point 3 to
create a continuous waveform.