RIGOL DG4000 Series - Manual (Page 135)

Chapter 6 Sweep RIGOL
DG4000 Series User’s Guide 6-1
Chapter 6 Sweep
DG4000 can output sweep from a single channel or from dual channels at the
same time. In sweep mode, the generator varies its output from the start
frequency to end frequency within the specified sweep time. DG4000 supports
linear, log and step sweep modes, allows users to set start hold, end hold and
return time, supports internal, external or manual trigger source and can generate
sweep output for Sine, Square, Ramp and arbitrary waveform (except DC).
Subjects in this chapter:
 To Enable Frequency Sweep
 Start Frequency and End Frequency
 Center Frequency and Frequency Span
 Sweep Type
 Sweep Time
 Return Time
 Mark Frequency
 Start Hold
 End Hold
 Sweep Trigger Source
 Trigger Output Edge