RIGOL DG4000 Series - Manual (Page 149)

Chapter 7 Burst RIGOL
DG4000 Series User’s Guide 7-3
When Burst is enabled, press Type to select “N_Cyc”. The parameter “Cycles” on
the screen is highlighted and could be edited. At this point, use the numeric
keyboard or knob to change the Cycles, the default is 1 and the available range is
from 1 to 1 000 000 (external or manual trigger) or 1 to 500 000 (internal trigger).
Figure 7-1 N Cycle Burst
Infinite Burst
In Infinite mode, the cycle number of the waveform is set as an infinite value. The
generator outputs a continuous waveform after receiving trigger signal. Waveform
functions that support infinite burst include Sine, Square, Ramp, Pulse and
arbitrary waveform (except DC).
For infinite burst, “Ext” or “Manual” trigger source could be used. Besides, users
can set the “Start Phase”, “Delay”, “SlopeIn” (external trigger) and “TrigOut”
(manual trigger).