RIGOL DG4000 Series - Manual (Page 170)

RIGOL Chapter 9 Store and Recall
DG4000 Series User’s Guide 9-8
selected would be displayed in the “Pinyin Input Area”. After inputting the
pinyin of a Chinese character, use the numeric keyboard to select the No.
of the desired Chinese character (if the desired Chinese character is not
currently displayed, use the direction key to open the next page) and the
Chinese character selected would be displayed in the “Filename Input
Area”. Use the same method to input all the Chinese characters needed.
You can press Delete to delete the character in the “Pinyin Input Area”
and then the Chinese character at the cursor currently in the “Filename
Input Area”.
4. To Save File
After finishing inputting filename in the filename input interface, press Save,
the generator will save the file under the currently selected directory with the
specified filename and file type and display corresponding prompt message
when the save operation succeeds.
Recall
1. To Select File Type
Follow the introduction in To Select File Type to select the type of file to be
recalled. Note that if the current File Type is “All File”, the file to be recalled is
the currently selected file.
2. To Select the File to be Recalled
Set Browser as “Dir” and use the knob to select the directory in which the file
to be recalled is stored. Then set Browser as “File”, and use the knob to
select the file to be recalled.
3. To Recall File
Press Read, the generator will read the currently selected file and display
corresponding prompt message when the read operation succeeds.