RIGOL DG4000 Series - Manual (Page 184)

RIGOL Chapter 10 Utility and System Settings
DG4000 Series User’s Guide 10-12
To Configure the Remote Interface
DG4000 is configured with USB and LAN interfaces and supports users to
configure the interface parameters for remote communication.
Press Utility  I/O Setup to open the I/O setting menu and set the LAN
interface parameters for remote communication or select the type of device
connected to the USB interface.
LAN Setting
Press Utility  I/O Setup  LAN to open the LAN parameters configuration
interface as shown in the following figure. Users can examine network status and
configure network parameters.
Figure 10-3 LAN Setting Interface
Network Status
Different prompt messages will be provided by the generator based on the current
network status.
 Connected: LAN connection is successful.
 Disconnect: LAN connection is unsuccessful.
Current IP Configure Mode
Network Status
IP Configure Mode status
MAC Address
VISA Descriptor