RIGOL DG4000 Series - Manual (Page 204)

RIGOL Chapter 10 Utility and System Settings
DG4000 Series User’s Guide 10-32
Restore Default
Restore the generator to its default state or user-preset states.
 Default State: the parameter values are as shown in the table below. Note
that items marked with “*” will not be affected by the preset operation.
 User-preset States: correspond to the 10 state files stored in internal memory.
Press Utility  Preset to select “Default” or one of “User1” to “User10”. Press
Preset at the front panel under any state to switch the instrument to the specified
state. Note that before selecting “User1” to “User10”, make sure that valid state
file is stored in the corresponding storage location.
Table 10-1 Factory Default Values
Parameters Defaults
Channel Parameters
Current Carrier Waveform
Sine
Output Resistance HighZ
Sync Output On
Sync Polarity Pos
Output Polarity Normal
Noise OFF
Noise Scale 10%
Coupling Off
Coupling Base CH1
Phase Deviation 0°
Frequency Deviation 0μHz
Amplitude Deviation 0Vpp
Basic Waveform
Frequency
1kHz
Amplitude 5Vpp
Amplitude Unit Vpp
Offset 0V
DC
Start Phase 0°