Print, Print -23 – RIGOL DG4000 Series User Manual
Page 195
Chapter 10 Utility and System Settings
DG4000 Series User’s Guide
10-23
Users could store the contents displayed on the screen into external USB storage
device in picture format or print them via PictBridge printer. Press Utility Print
to open the print setting interface.
1. To Print the Screen Using PictBridge Printer
First, connect the pictBridge printer. Connect the USB Device interface of the
signal generator to the USB Host interface of the Printer using USB cable (as
shown in the figure below).
Press Utility I/O Setup USB Dev to set the device type to “Printer”.
Press Utility Print Dest to select “Printer”. Then, press PictBridge to
enter the print setting menu.
Copies: press this softkey and use the knob to input the number of
copies to be printed. The range is from 1 to 1000.
Palette: press this softkey to set the color of the image to “Gray” or
“Color”.
Inverted: press this softkey to enable or disable inverted print.
2. To Store Screen to USB Storage Device
Please connect a USB storage device first. When the connection succeeds, an
icon will be displayed in the status bar on the screen and the
corresponding prompt message will be displayed.
Press Utility Print Dest to select “U Disk” and then press Format to
set to store the screen picture in “Bmp” or “Jpeg” format.
3. To Execute Print
Press Print at the front panel and the generator will print the screen via the
PictBridge printer or store the screen in USB storage device in picture format
according to the preset configuration.
DG4000
PictBridge Printer
USB Host USB Device
USB Cable