Emerson Process Management MICRO MOTION 2400S User Manual
Micro motion, Model 2400s transmitters for devicenet
Table of contents
Document Outline
- Contents
- Before You Begin
- Flowmeter Startup
- Using the Transmitter User Interface
- Connecting with ProLink II or Pocket ProLink Software
- Using a DeviceNet Tool
- Required Transmitter Configuration
- Using the Transmitter
- Optional Configuration
- 8.1 Overview
- 8.2 Configuring volume flow measurement for gas
- 8.3 Configuring cutoffs
- 8.4 Configuring the damping values
- 8.5 Configuring the flow direction parameter
- 8.6 Configuring events
- 8.7 Configuring slug flow limits and duration
- 8.8 Configuring status alarm severity
- 8.9 Configuring the display
- 8.10 Configuring digital communications
- 8.11 Configuring device settings
- 8.12 Configuring sensor parameters
- 8.13 Configuring the petroleum measurement application
- 8.14 Configuring the enhanced density application
- Pressure Compensation and Temperature Compensation
- Measurement Performance
- Troubleshooting
- 11.1 Overview
- 11.2 Guide to troubleshooting topics
- 11.3 Micro Motion customer service
- 11.4 Transmitter does not operate
- 11.5 Transmitter does not communicate
- 11.6 Checking the communication device
- 11.7 Diagnosing wiring problems
- 11.8 Zero or calibration failure
- 11.9 Fault conditions
- 11.10 Simulation mode for process variables
- 11.11 Transmitter LEDs
- 11.12 Status alarms
- 11.13 Checking process variables
- 11.14 Checking slug flow
- 11.15 Checking the sensor tubes
- 11.16 Checking the flow measurement configuration
- 11.17 Checking the characterization
- 11.18 Checking the calibration
- 11.19 Checking the test points
- 11.20 Checking sensor circuitry
- Default Values and Ranges
- Menu Flowcharts
- Device Profile
- C.1 Overview
- C.2 Analog Input Point Object (0x0A)
- C.3 Gas Standard Volume Object (0x64)
- C.4 Calibration Object (0x65)
- C.5 Diagnostics Object (0x66)
- C.6 Sensor Information Object (0x67)
- C.7 Local Display Object (0x68)
- C.8 API Object (0x69)
- C.9 Enhanced Density Object (0x6A)
- C.10 Totalizer and inventory measurement unit codes
- C.11 Process variable codes
- C.12 Alarm index codes
- Display Codes and Abbreviations
- Index