Emerson Process Management MICRO MOTION 2400S - Manual (Page 154)

146 Micro Motion ® Model 2400S Transmitters for DeviceNet ™
Device Profile
C.3 Gas Standard Volume Object (0x64)
104 Damping REAL Set NV Density damping value Unit = seconds
105 Cutoff REAL Set NV Value below which density
will be reported as 0
106 Meter factor REAL Set NV A multiplier to the
calculated density
Table C-4 Analog Input Point Object (0x0A) – Instance 4 (temperature)
Attrib
ID
Name Data type Service Mem Description Comments
3 Value REAL Get V Current value of
temperature process
variable Based on Attribute 8
4 Status BOOL Get V Point status • 0 = Good
• 1 = Alarm state
8 Value data type USINT Get V Data type used to report
mass flow process
variable • 1 = REAL
102 Value
engineering
units UINT Set NV Temperature
measurement unit See Table 6-6 for unit
codes.
104 Damping REAL Set NV Temperature damping
value Unit = seconds
Table C-5 Gas Standard Volume Object (0x64) – Instance 1
Attrib
ID
Name Data type Service Mem Description Comments
1 Gas standard
volume flow REAL Get V Current value of gas
standard volume flow
process variable
2 Gas standard
volume total REAL Get
Reset
(1)
V Current value of gas
standard volume total
3 Gas standard
volume
inventory REAL Get
Reset
(2)
V Current value of gas
standard volume
inventory
4 Reference
density REAL Set NV Reference density of gas
being measured
5 Gas standard
volume flow
units UINT Set NV Gas standard volume flow
measurement unit See Table 6-4 for unit
codes.
6 Gas standard
volume total and
inventory units UINT Get V Gas standard volume total
and inventory units Transmitter
automatically
determines this based
on Attribute 102.
See Table C-14 for unit
codes.
Table C-3 Analog Input Point Object (0x0A) – Instance 3 (density) continued
Attrib
ID
Name Data type Service Mem Description Comments