Emerson Process Management MICRO MOTION 2400S - Manual (Page 151)

Configuration and Use Manual 143
D
e
vice Pr
ofile
In
de
x
Displa
y Codes
Men
u
s
Appendix C
Device Profile
C.1 Overview
This appendix documents the most commonly used portions of the Model 2400S DN transmitter’s
device profile, including class/instance/attribute information and required codes.
The following object classes and instances are documented:
• Analog Input Point Object (0x0A), Instance 1 (mass flow) – see Table C-1
• Analog Input Point Object (0x0A), Instance 2 (liquid volume flow) – see Table C-2
• Analog Input Point Object (0x0A), Instance 3 (density) – see Table C-3
• Analog Input Point Object (0x0A), Instance 4 (temperature) – see Table C-4
• Gas Standard Volume Object (0x64), Instance 1 – see Table C-5
• Calibration Object (0x65), Instance 1 – see Table C-6
• Diagnostics Object (0x66), Instance 1 – see Table C-7
• Sensor Information Object (0x67), Instance 1 – see Table C-8
• Local Display Object (0x68), Instance 1 – see Table C-9
• API Object (0x69), Instance 1 – see Table C-10
• Enhanced Density Object (0x6A), Instance 1 – see Table C-11
Note: The listings for the Sensor Information and Enhanced Density Object instances are not
complete: only the most commonly used attributes are shown here.
The following codes are documented:
• Totalizer and inventory measurement unit codes – see Tables C-12 through C-14
• Process variable codes – see Table C-15
• Alarm index codes – see Table C-16
For measurement unit codes used for process variables, see Section 6.3.
For complete documentation of the device profile, see the manual entitled Micro Motion Model 2400S
Transmitters for DeviceNet: Device Profile.