Epson PhotoPC 650 - Manual (Page 57)

Getting Photos Into Your Computer 4-5
A
B
5 You see the screen below. Click CD-ROM drive . Then
click Next .
6 You see a message that a driver was located for the USB
cable, called
LexarMedia JumpShot . Click Next ,
then click Finish on the next screen.
7 You see the Add New Hardware Wizard screen again.
Repeat steps 2 through 4.
8 You see a message that a driver was located for the USB
CompactFlash card, called
LexarMedia USB CF
Mass Storage Device . Click Next , then click Finish
at the next screen.
To check if your driver installation was successful, do the
following:
1 Click Start , point to Settings , and click Control
Panel .
2 Double-click the System icon.
3 Click the Device Manager tab.
4 Click the + next to Universal serial bus controller
in the device list. You should see LexarMedia
JumpShot listed as a USB device.
Transferring Pictures with Windows 98
Follow these steps to transfer your pictures via the JumpShot
USB cable with Windows 98:
1 Right-click Start , then select Explorer from the pop-
up list. (Or click Start , point to Programs , and click
Windows Explorer .)
2 You see the Exploring window. Locate the USB
CompactFlash card drive.
click CD-ROM
drive