Modified constants menu (-verify-), Auto-tuning menu (-a.tune-) – Yaskawa iQpump Drive User Manual User Manual
Page 62

3.6 Programming Menu (-ADV-)
62
YASKAWA TM.iQp.01 iQpump Drive User Manual
◆ Modified Constants Menu (-VERIFY-)
This menu is used to set/read the parameters that have been modified from their original factory default settings. Follow the key
operations below (
) to access the Modified Constants Parameter Menu.
Figure 3.8 Modified Constants Menu Access Procedure
Note: If there are not any parameters that have been modified from their original factory default settings, then the display will
state “None Modified.” Otherwise, use the “increase” and “decrease” keys to scroll through the “Modified Constants”
list.
◆ Auto-Tuning Menu (-A.TUNE-)
This menu is used to auto-tune the iQpump drive in order to optimize motor control as well as utilize the bi-directional speed search
feature. Follow the key operations below (
) to access the Auto-Tuning Menu.
Figure 3.9 Auto-Tuning Menu Access Procedure
Use
and
keys to scroll through the Auto-Tuning Parameter List.
Table 3.13 Auto-Tuning Parameter List
Auto-Tuning Parameters
T1-02 Mtr Rated Power
T1-04 Rated Current
-VERIFY-
** Main Menu **
- - - - - - - - - - - - - -
Modified Consts
See Note 1
x4
See Note 1
-A.TUNE-
** Main Menu **
- - - - - - - - - - - - - -
Auto-Tuning
-A.TUNE-
Mtr Rated Power
- - - - - - - - - - - - - - - - - - - -
T1-
02
= 0.40kW
(0.00~650.00)
“0.40kW”
x5